Analisis Respon Tekanan Air Pori Terhadap Muka Air Waduk Pada Bendungan Jatibarang

Analysis of Pore Water Pressure Response to Reservoir Water Level in Jatibarang Dam

  • Angga Setyadi Magister Teknik Sipil; Universitas Diponegoro; Jl. Prof. Soedarto, SH, Tembalang, Semarang, Indonesia
  • Suharyanto Suharyanto Departemen Teknik Sipil; Universitas Diponegoro; Jl. Prof. Soedarto, SH, Tembalang, Semarang, Indonesia
  • Sutarto Edhisono Departemen Teknik Sipil; Universitas Diponegoro; Jl. Prof. Soedarto, SH, Tembalang, Semarang, Indonesia

Abstract

The construction of dams is very important for fulfill water demand and as flood control. In addition to having many benefits, a dam also has a high risk. The stability of the dam is strongly influenced by the magnitude of the pore water pressure. The purpose of the study was to determine the response of pore water pressure to the reservoir water level, as well as to find out the comparison of the results of pore water pressure analysis using plaxis 2D and piezometer instrument readings. The piezometer readings are graphed as a function of the reservoir water level. Based on the graph, it can be seen that the piezometer readings correspond to the fluctuations in the reservoir water level. The piezometer upstream side have a faster response to the reservoir water level, which is between 14 to 41 days. While downstream piezometers have a longer response, which is between 25 to 61 days. Pore ​​water pressure analysis using plaxis 2D at location P.17 (upstream) resulted in a smaller value than piezometer reading. While at location P.18 (downstream) it produces a greater value than the piezometer reading. The relative error value of the two analyses is 7.73% < 12% is still considered good, so the difference is acceptable.

Downloads

Download data is not yet available.

References

Ardiansyah, R. H., & Khurtumi, N. D. (2022). Perilaku Tekanan Air Pori pada Bendungan Bajulmati Mulai Pengisian Hingga Tahun 2020. Fropil (Forum Profesional Teknik Sipil), 9(2). https://doi.org/10.33019/fropil.v9i2.2553

Ariansyah, G. B., Sobriyah, & Wahyudi, A. H. (2013). Analisis Tinggi Muka Air Waduk Wonogiri Berdasarkan Data Hujan Jam-jaman. Matriks Teknik Sipil, 1(4). https://doi.org/10.20961/mateksi.v1i4.37499

Badan Standarisasi Nasional. (2015). SNI 8062 Tata Cara Desain Tubuh Bendungan Tipe Urugan.

Badan Standarisasi Nasional. (2016). SNI 8064 Metode Analisis Stabilitas Lereng Statik Bendungan Tipe Urugan.

Balai Besar Wilayah Sungai Pemali Juana. (2014). As Built Drawing Integrated Water Resources and Flood Management Project for Semarang.

Brinkgreve, R. B. J., Zampich, L. M., & Manoj, N. R. (2019). Plaxis 2D Tutorial Manual Connect Edition V20.

CTI Engineering International Co., L. (2008a). Design Review Report Jatibarang Multipurpose Dam Vol.1.

CTI Engineering International Co., L. (2008b). Design Review Report Jatibarang Multipurpose Dam Vol.3.

Huda, A. L., Wardani, S. P. R., & Suharyanto. (2019). Evaluasi Tekanan Air Pori dan Rembesan pada Bendungan Panohan. Reka Buana, 4(2).

Keyvanipour, M., Moharrampour, M., & Ranjbar, M. K. (2013). An Evaluation and Comparison of Sirjan’s Embankment Behavior with Instrumentation Data and Software Plaxis. Industrial Science, 1(1). http://oldindsci.lbp.world/Article.aspx?aid=6&vid=1

Novak, P., Moffat, A. I. B., & Nalluri, C. (2007). Hydraulic Structures Fourth Edition (4th ed.).
Published
2023-01-11